Posted November 10, 2018 03:02:10A few weeks ago, I posted a picture on Instagram of what I thought was a foam pipe insulation I made to use for my sock.
I knew I was dreaming, so I decided to build a sock with the foam pipe.
I started by cutting some cardboard out of 1/4 inch thick and sanding the pieces together.
I also cut some pieces of foam and put it in a plastic bag with a mesh to protect it from rain.
After a bit of work, I made the first prototype.
It had a hole at the bottom, but the hole was very shallow and was only a few inches wide.
Then I used a sanding block to make a little hole at about 2 inches in diameter and sanded it down.
After I sanded down the hole, I used the sanding tool to make another hole in the foam.
This was where I cut the two pieces together to make the foam sleeve.
I used some hot glue to hold the foam together and it worked just fine.
After a few hours of work with the glue, I was ready to go to the store to get the foam tube.
I cut out a tube and cut the foam out of it.
I used the foam to insulate the tube.
You can see that the foam is about 2.5 inches long.
With a foam tube in place, I could attach it to the sock by attaching the foam tubing to the underside of the sock.
I did this by using a tape measure to measure how long each piece of foam would be.
Now I could tighten the tube to fit the sock without having to use any glue.
As you can see, it is quite snug.
I can’t help but be proud of myself when I think about all of the hard work I put into this project.
I thought I’d share a few more pictures of the project.
It took me a while to complete this project, so you can imagine the frustration I felt when it was finished.
Here’s a closer look at the foam insulation.
The insulation was a lot easier to work with than I had hoped.
First, I cut a piece of 4×4 to fit into the tube so that I could cut out the foam sleeves.
Next, I wrapped the tube around the foam and tapered it to about 2 inch.
Finally, I secured the foam with some adhesive tape and used a screwdriver to secure the foam into place.
I have my own foam sock that looks like a tube.
It’s pretty darn cute!